Fracarro FRPRO 10A Instructions D'emploi page 40

5.3.1 PROGRAMMING THE UHFx INPUT AND ASSOCIATED CLUSTERS
Each cluster shall be individually programmed by setting the cluster's initial channel, the cluster's end chan-
nel, the channel type (analogue or digital or cluster OFF), the cluster gain and the UHF input.
To program each cluster, refer to the following flow-chart:
UHF 3 UHF 3
<DDDDDDDDDD> -- <DDDDDDDDDD> 01
UHF 3
<DDDDDDDDDD> 02
Setting the input dynamics of
UHF3 input
UHF 3
UHF 3
20
DYNAMIC IN
UHF 3
00
Enter the "INPUT – UHF3" menu to program all clusters (to select a different input, use the UP/DOWN arrows
from the INPUT menu). The following will appear:
Indication of the input you are programming
Indicate the 10 clusters in the Profiler
D: cluster with Digital channels;
A: cluster with Analogue channels;
X: cluster off;
_: the cluster cannot be selected for this UHF input
E: cluster in Error (possible overlapping of channels with other clusters);
If the cluster is associated to a UHF input that is different from the input you are programming:
1: cluster associated to the UHF1 input;
2: cluster associated to the UHF2 input;
3: cluster associated to the UHF3 input;
Programming
cluster number 01
CELL 1 - UHF3
E21 - E21
E21 : E21 - DTT
Changing cluster
Programming
cluster number 02
E22 - E22
CELL 1 - UHF3
CHANNEL TYPE
*
Visible only after
*
enabling the cell (by CELL 1 - UHF3
selecting the channel
GAIN
type)
CELL 1 - UHF3
To select
**
INPUT
00 dB
01 dB
**
...
Visible only if the
20 dB
cell can be associated
to other inputs (fig 2.1
of the manual)
UHF 3
<XXXXXXXXXX> --
40
CELL 1 - UHF3
Selection of the initial channel and
E21 : E21 - DTT
end channel of the cluster (CELL
1) associated with the UHF3 input
Selection start
channel of cluster
CELL 1 - UHF3 CELL 1 - UHF3
E22 : E22 - DTT E22 : E22 - DTT
Selection of the finish
channel of the cluster
CELL 1 - UHF3
E22 : E26 - DTT
CELL 1 - UHF3
OFF
To select
CELL 1 - UHF3
DIGITAL
CELL 1 - UHF3
ANALOGUE
CELL 1 - UHF3
20
To select
CELL 1 - UHF3
00
CELL 1 - UHF3
UHF3
To select
CELL 1 - UHF3
UHF1
Setting the signal type of CELL 1
of the UHF3 input
OFF
Digital
Analogue
Setting the gain of the CELL 1 of
the UHF3 input
00 dB
01 dB
...
20 dB
Setting the UHF input associated
to the selected cell
UHF3
UHF2
UHF1
Use
The
me
Pre
initi
to c
A c
Usi
•
•
•
Not
•
•
Fol
Clu
The
2.1
of a