Pre-Operation Check - Honda F560 Manuel De L'utilisateur

Place the tiller on a firm level surface and hold the tiller level (i.e. with
the tires, rotary tines and drag bar). Stop the engine before starting
service of the tiller. Servicing the tiller on an unstable surface of the
ground or without stopping the engine can cause injury and/or
equipment damage.
Daily inspection and service of tiller is essential for safe and reliable
operation. Perform the following check before operation.
1.Tiller outside
Check for fuel and engine oil leaks.
Make sure that there are no flammable materials (dust, straw, etc.) near
the engine.
2.Control lever function
Check that the lever operates smoothly.
Check if there is the specified amount of freeplay at the tip of the lever
(see pages 47 and 48).
3.Wiring and cables
Check the insulation of each wire and cable for tears and cuts.
Check if there is any wire or cable pinched by the neighboring parts.
4.Engine operation
• Start the engine. Check for abnormal sounds. (See pages 20 and 21
for starting procedure.)
• Check that the engine stops securely by operating the engine switch.
(See pages 34 through 36 for stopping procedure.)
• If you notice any other abnormal symptoms, consult with your
authorized Honda dealer promptly.
5.Bolts and nuts
Check for looseness in fastened parts. Securely tighten all loose parts.

4. PRE-OPERATION CHECK

13