Carrera RC Jeep Wrangler Rubicon Instructions De Montage Et D'utilisation page 11

• When changing from the first battery to the second battery, you must stop run­
ning for at least ten minutes. At the next change, a pause of at least 20 minutes
is absolutely essential.
• Avoid constant motor operation.
• If the car switches itself off several times one after another, the battery is dead.
Please recharge the battery.
• After 30 minutes inactivity, the controller and vehicle switch off automatically.
To restart, switch the On/OFF switch on the controller & the car to OFF and
then back to On.
• To switch off after use, follow the steps in the reverse order.
• After use, remove or disconnect the battery. Always recharge the battery
immediately after use to prevent its becoming deep discharged.
• Always keep the rechargeable battery stored outside the vehicle.
• Clean the Carrera RC car after use.
Controller functions
1
2
3
Troubleshooting
Problem Cause
Either the switch on the controller or the car is set to OFF.
Car does not move
There is no rechargeable battery in the car or the battery is too weak.
The car has come to a stop at an obstacle.
The battery or rechargeable battery in the transmitter or model is too
weak.
The remote control is possibly not correctly frequency bound with the
receiver on the model
The transmitter has switched itself off after 30 minutes.
The vehicle is very warm.
The overheat protection has caused the car's motor to cut out due to
excess temperature.
Vehicle starts moving unintentionally.
Car cannot be controlled
For the latest version of these operating instructions and information on replacement and spare parts available, please visit
Errors and changes excepted
Colours / final design – changes excepted
SERVO TROnIC
You can use the joysticks to carry out
precise steering and driving manoeu-
vres.
Left joystick: forwards and backwards
at different speeds
Right joystick: steering right and left
with variable lock for precise steering
Thanks to 2.4 GHz technology, up to
16 cars can be run together on one
race-track. This is possible even
without harmonising frequencies
between the racing drivers.
4
5
6
Operating the rope winch
1
2
3
Solution
Switch on.
Insert charged battery.
The voltage surge protector has switched the car off.
Turn the ON/OFF switch on the car to OFF, then back to ON, and
place the car on a clear surface.
Insert new battery or recharged battery.
Carry out a frequency bind between the model and the remote control
as described in "Now you can drive the car"
To restart, switch the ON/OFF switch on both controller & vehicle to
OFF and then back to ON..
Switch both car and controller off and allow the car to cool down for
about 30 minutes.
Switch off the receiver.
Leave the RC car to cool down for approx. 30 minutes.
First turn on the transmitter, only then the vehicle.
11
The joysticks are removable.
Alternatively, the vehicle can be
controlled with a rocker.
The joysticks can be stored in the
special compartment at the back of the
controller.
Attach the lanyard to the eyelet on the
controller and let the controller hang
from your neck.
CAuTIOn! Danger of strangulation!
Release the winch hook from the
bumper and press the release button
to the right of the winch.
While keeping the release button
pressed, unwind the winch until the
rope is of the desired length and hook
to an object or position.
The tensile force of the winch is up to
2.5 kg.
Press the button on the right-hand side
of the controller to activate the winch's
roll-up mechanism.
carrera­rc.com in the service area.
Technical changes and design-related changes excepted
Pictograms = symbolic photos