Bosch Indego 10 C Notice Originale page 34

OBJ_BUCH-2369-005.book Page 34 Wednesday, November 9, 2016 1:42 PM
34 | English
limitations or to their lack of experi-
ence or knowledge, are not capable
of safely operating the docking sta-
tion or power supply, may only use
this docking station and power sup-
ply under supervision or after hav-
ing been instructed by a responsible
person. Otherwise, there is danger of
operating errors and injuries.
 The voltage indicated on the power
supply must correspond to the volt-
age of the power source.
 The power supply should ideally be
connected into a socket that is pro-
tected by a circuit-breaker that is ac-
tuated by a 30 mA residual current.
Check your Residual Current Device
(RCD) at regular intervals.
 The supply cord must be inspected
for signs of damage at regular inter-
vals and may only be used if in perfect
condition.
 If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
 Only use or replace cables for the
docking station and power supply
with Bosch approved parts.
 Never touch the mains plug with wet
hands.
 Do not run over, crush or pull the ca-
bles. Protect the cables from heat, oil
and sharp edges.
The power supply is double insulated
for safety and requires no earth con-
nection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Contact
your Bosch Service Centre for details.
F 016 L81 666 | (9.11.16)
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
The connection lead must be inspected
for signs of visible damage and ageing
at regular intervals and may only be
used if in perfect condition.
Products sold in GB only: Your prod-
uct is fitted with a BS 1363/A approved
electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket
outlets, it should be cut off and an ap-
propriate plug fitted in its place by an
authorised customer service agent.
The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the garden product in a better
and safer manner.
Symbol Meaning
Wear protective gloves
Permitted action
Prohibited action
Accessories/Spare Parts
Intended Use
The garden product is intended for domestic lawnmowing.
Bosch Power Tools