Attaching The Non-Skid Pads; Rotating The Speaker Badge - Pioneer X-CM32BT-K Mode D'emploi

02 Part names and functions

Attaching the Non-skid pads

Apply the accessory non-skid pads to the bottom surfaces of
the speakers.
Important
• Use the speaker is usually in an upright position.
When placing speakers upright
When placing the speakers vertically upright, attach the non-
skid pads to the bottom surface of the speakers.
When placing speakers horizontally
When placing the speaker horizontally, attach the non-skid
pads to what will be the bottom surface of the speakers.
8
En

Rotating the Speaker Badge

The grill frame speaker badge can be rotated. Operate as
follows.
1
(2), and turn left (3).
The speaker badge will rotate.
The bottom surface
of the speaker
If the speaker badge does not rotate doing the above step 1,
try the following steps 2 to 3.
2
The bottom surface of
the speaker when
using it horizontally
3
in a clockwise direction using a plus driver.
• Do not rotate the screw in a counter-clockwise direction
Grasp the speaker badge (1), pull forward
3
2
Detach the speaker grill.
Rotate the screws on the backside of the grill
Backside of speaker grill
Important
as it may cause the badge to fall off.
1