DeWalt DXCMH1608WB Guide D'utilisation page 20

GLoSSArY
CfM: Cubic feet per minute.
sCfM: Standard cubic feet per minute; a unit of measure of air
delivery.
PsI: Pounds per square inch; a unit of measure of pressure.
Code Certification: Products that bear one or more of the fol-
lowing marks: UL ® *, CUL, ETL
by OSHA certified independent safety laboratories and meet the
applicable Standards for Safety.
®
* UL is a registered trademark of Underwriters Laboratories and
ETL ® is a registered trademark of Electrical Testing Laboratories.
California Code: Unit may comply with California Code 462 (l) (2)/
(M) (2). Specification/model label is on the side of the air tank on
units that comply with California Code.
unloader Blow-off Pressure: All models are continuous running
units controlled by air tank pressure. When the maximum air tank
pressure is obtained, the unloader valve will blow-off. This will
cause the compressor to exhaust the air to the atmosphere and
not the tank. This decreases the load on the engine and allows it
to run at a near no-load condition.
unloader reset Pressure: When the air tank pressure drops to
a predetermined point, the unloader valve closes. The air tank
pressure will now increase until it reaches the unloader blow-off
pressure.
® *, CETL, have been evaluated
troubleshooting Guide
This section provides a list of the more frequently encountered
malfunctions, their causes and corrective actions. The operator or
maintenance personnel can perform some corrective actions, and
others may require the assistance of a qualified D
or your dealer.
Problem
Code
Excessive air tank pressure-safety valve pops off .................
1
Air leaks .................................................................................
2
Continuous air leak at unloader valve. ...................................
3
Air leaks in air tank or at air tank welds .................................
4
Air leaks between head and valve plate .................................
5
Air leaks from safety valve......................................................
6
Compressor is not supplying enough air to operate
accessories .............................................................................
2, 7, 8, 9, 10, 12, 13
Restricted air intake. ...............................................................
12
Excessive vibration .................................................................
14, 15
20
e WALT technician