Preparing The Tool - DeWalt DCN682 Guide D'utilisation

To operate the stapler in sequential actuation mode:
1. Slide the selector switch
icon .
2. Fully depress nosepiece against the work surface (motor
will start).
3. Pull trigger (staple will drive into work surface).
4. Release trigger.
5. Lift nosepiece off work surface.
6. Repeat steps 2 through 4 for next application.
NOTICE: The contact trip needs to be depressed
followed by a trigger pull for each staple followed by
a release of both the contact trip and trigger after
each staple.
Fig. H
Rapid Sequential Mode
In rapid sequential mode, the motor rotation speed is
automatically restored after driving a staple to allow fast
consecutive stapling. While offering the ability to drive
more staples in less time, this mode quickly depletes the
battery charge.
1. Using the mode selector switch
sequential mode.
2. Release the trigger lock-off
3. Push the contact trip against the work surface.
5
4. Pull the trigger switch
1
5. Release the trigger and raise the stapler from the
work surface. nOTE: The tool motor returns to full
speed automatically without the contact trip
being depressed.
6. Repeat steps 3–5 to actuate the next staple.

Preparing the Tool


WARNING: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This can
seriously affect the life and performance of the tool.
nOTE: The battery pack is not fully charged out of the
carton. Follow instructions outlined (see Charging
a Battery).
1. Read the Safety Instruction section of this manual.
2. Wear eye and ear protection.
3. Ensure magazine is empty of all fasteners.
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. nEVER use
a tool that has the contact trip restrained in the
actuated position.
5. Keep tool pointed away from yourself and others.
6. Insert fully charged battery pack.
7 to expose the single staple
7
(Fig. H)
7 to select the Rapid
.
2
to actuate the tool.
5
Using the Trigger Lock-off (Fig. I)

WARNING: To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig. I)
when the tool is not in use.

WARNING: To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack from
tool and remove staples from magazine before
making adjustments.
Each D WALT stapler is equipped with a trigger lock-off
e
which when pushed to the right as shown in Figure I,
prevents the tool from firing a staple by locking the trigger
and bypassing power to the motor.
Fig. I
2
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off whenever any adjustments are made or when
tool is not in immediate use.
NOTICE: Do not store tool with battery pack installed.
To prevent damage to the pack and to ensure best
battery life, store battery packs out of the tool or
charger in a cool, dry location.
Loading the Tool (Fig. J)

WARNING: Keep the tool pointed away from yourself
and others. Serious personal injury may result.

WARNING: Always remove battery pack before
loading or unloading staples. Serious personal injury
may result.

WARNING: Never load staples with the contact trip or
trigger activated. Personal injury may result.
1. Press magazine latch
14
fully.
2. Ensure staple is loaded so that crown of staple sits
against inside surface of magazine
3. Close sliding magazine until the magazine latch
clips snuggly.
English
2
and open sliding magazine
6
6
11