Hints And Tips - AEG FEE62800PM Notice D'utilisation

Masquer les pouces Voir aussi pour FEE62800PM:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

40
www.aeg.com
2. Press Program again and again until
the indicator of the programme you
want to select comes on.
The display shows the programme
duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running
phase comes on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
3. Press Start to start the countdown.
• The delay indicator comes on to
confirm the start of the
countdown.
• The countdown starts to decrease
with steps of 1 hour. Only the last
hour will decrease with steps of 1
minute.
When the countdown is completed, the
programme starts and the indicator of
the running phase comes on. The delay
indicator goes off.
Opening the door while the
appliance operates
If you open the door while a programme
is running, the appliance stops. It may
affect the energy consumption and the
programme duration. When you close
the door, the appliance continues from
the point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme will end.
This will not happen if the
door is opened by AirDry.

10. HINTS AND TIPS

10.1 General
The following hints will ensure optimal
cleaning and drying results in daily use
CAUTION!
Do not try to close the
appliance door within 2
minutes after AirDry
automatically opens it, as
this may cause damage to
the appliance. If, afterwards,
the door is closed for
another 3 minutes, the
running programme ends.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you
have to set the programme and options
again.
Press and hold simultaneously Delay and
Option until the appliance is in
programme selection mode.
Cancelling the programme
Press and hold simultaneously Delay and
Option and until the appliance is in
programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
All buttons are inactive except for the
on/off button.
1. Press the on/off button or wait for
the Auto Off function to
automatically deactivate the
appliance.
If you open the door before the
activation of Auto Off, the appliance
is automatically deactivated.
2. Close the water tap.
and also help to protect the
environment.
• Remove larger residues of food from
the dishes into the waste bin.

Publicité

Table des Matières
loading

Table des Matières