Hansgrohe E 04228 0 Série Instructions De Montage / Mode D'emploi / Garantie page 3

Technical Information / Données techniques / Datos tecnicos
Recommended water
pressure
Max. water pressure
Recommended hot
water temp.
Max. hot water temp
Flow rate
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.
* Vous devez connaître et respecter tous les codes de plomberie locaux applicables pour le réglage de la température du
chauffe-eau.
*Debe conocer y cumplir todos los códigos locales aplicables para ajustar la temperatura del calentador de agua.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• This trim is for use with iBox Universal Plus
model 01850181 (not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be
no higher than 120°F. In Massachusetts,
the maximum output temperature can be no
higher than 112° F.
• This product is for use with shower heads rated
at 1.5 GPM (5,6 l/min) or higher.
• Adjust the rotational limit stop (see page 18)
Pression d'eau recommandée Presión recomendada
Pression d'eau maximum
Température recommandée
d'eau chaude
Température maximum d'eau
chaude
Capacité nominale
en servicio
Presión en servicio max.
Temperatura recomen-
dada del agua caliente
Temperatura del agua
caliente max.
Caudal máximo
during installation. Further adjustments may
be necessary due to seasonal water tempera-
ture changes.
• Do not install a shut-off device on either outlet
of this valve. Use of such a device can defeat
the ability of the valve to balance the hot and
cold water pressures.
• The pressure balance trim is suitable for a one-
function installation, such as a single shower-
head or handshower.
• The pressure balance trim may be used in a
tub/shower application using a diverter tub
spout.
• Keep this booklet and the receipt (or other
proof of date and place of purchase) for
this product in a safe place. The receipt is
required should it be necessary to request
warranty parts.
15 - 75 PSI
145 PSI
120º - 140º F*
176ºF*
5.5 GPM @ 44
PSI
3