Siemens TE 803 Série Mode D'emploi page 21

● Remove powder compartment 18 and
rinse under running water.
1.
2.
● Wipe out the inside of the tray holders.
Important: Drip tray 23 and coffee
grounds container 23c should be emptied
and cleaned daily to prevent mould from
developing.
Note: If the appliance is cold when
switched on, or if it is switched off after
dispensing coffee, it rinses automatically. In
other words, the system cleans itself.
Important: If the appliance has not been
used for a prolonged period of time (e. g.
after a vacation), clean the entire appliance
thoroughly, including the milk system 10
and brewing unit 20.
Cleaning the milk system
Important: The milk system 10 must be
cleaned immediately after use!
The milk system 10 can be pre-cleaned
automatically (see "Service programmes" or
cleaned manually.
TE803_806_1RW.indb 17
Dismantling the milk system 10 for cleaning:
● Pull the milk system 10 forward out of the
appliance.
14 neu!
3.
● Turn the upper part 10a in an anti-
clockwise direction and remove from the
lower part 10b.
7
● Clean the individual parts with detergent
solution and a soft cloth.
● Rinse all parts with clean water and dry.
● Put all the parts back together. The milk
frother can then be clicked back into
place in the appliance.
8
Info: All parts of the milk frother 10 can also
be put in the dishwasher.
en
17
08.05.2013 14:24:13