Bosch Professional GBH 18 V-EC Notice Originale page 13

OBJ_BUCH-1644-001.book Page 13 Thursday, May 24, 2012 9:40 AM
Action
Inserting SDS-plus Drilling Tools
Removing SDS-plus Drilling Tools
Selecting the operating mode and
rotation direction
Changing the chisel position (Vario-
Lock)
Adjusting the drilling depth X
Mounting the extraction system
(Saugfix)
Switching on and off and setting the
speed
Selecting accessories
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 174.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly in-
crease the exposure level over the total working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working pe-
riod.
Identify additional safety measures to protect the operator
Bosch Power Tools
Figure
5
6
7
8
9
X
10
11
–
from the effects of vibration such as: maintain the tool and the
accessories, keep hands warm, organise work patterns.
Maintenance and Cleaning
For safe and proper working, always keep the machine
and ventilation slots clean.
Clean the application tool, the tool holder, the power tool's
ventilations slots, and the battery's ventilation slots each time
after using.
English | 13
Please observe
1 619 929 K98 | (24.5.12)
Page
176
176
177
178
178
179
179
180