Schneider Airsystems UNM STS 1000-10-270 Notice D'utilisation D'origine page 11

Table of contents - Part 1
1.1 Scope of delivery ......................
1.2 Conventional use ......................
1.3 Technical data ..........................
1.4 Components.............................
1.5 Operation ................................
1.6 Maintenance.............................
1.7 Vessel inspections .....................
1.1 Scope of delivery
– Compressor with instruction manual
– Documents accompanying compressed air
vessel
– Rubber dampers
With version UNM STS ... XDK:
– Compressed air cold dryer with instruction
manual
1.2 Conventional use
The compressor is designed for generating
and storing compressed air only. Com-
pressed air is only suitable for compressed
air tools/devices/machines.
Any other type of use is considered contrary
to the intended use.
The compressor must not be used in poten-
tially explosive areas. Combustible, caustic
or toxic gases must not be sucked in!
1.3 Technical data
see Figs. 1a ...1h
1.4 Components
01 Compressor unit
02 Intake filter
03 Oil filler plug
04 Mini ball valve (oil drain)
05 Oil inspection glass
06 Pressure pipe
07 Check valve
08 Vessel
09 Ball valve at condensate drainage point
10 Pressure switch with ON/OFF switch
11 Safety valve
12 Pressure gauge (vessel pressure)
13 TÜV test flange
14 Electric motor
15 Cradle
16 V-belt
1
17 Belt guard grating
1
18 V-belt disc
1
19 Fan wheel
1
21 Silencer
22 Ball valve
1
23 Rubber dampers
1
2 With version UNM STS ... XDK:
24 Compressed air cold dryer
25 Bypass line
26 Connecting hose
1.5 Operation
With version UNM STS ... XDK:
1.5.1 With compressed air cold dryer
see Figs. 2a, 2b
1. Fold up safety bar (SB).
2. Push slide (S) slowly inwards so that
compressed air is slowly applied to the
compressed air cold dryer.
3. Important: Fold down safety bar (SB)
for locking slide.
1.5.2 Without compressed air cold dry-
er
see Figs. 2b, 2c
1. Fold up safety bar (SB).
2. Pull slide (S) slowly outwards.
3. Important: Fold down safety bar (SB)
for locking slide.
1.6 Maintenance
1.6.1 Clean the silencer insert
1. Unscrew silencer cover.
2. Pull out silencer insert and clean in soapy
water (max. 50°C).
3. Slide insert into position, screw on si-
lencer cover.
If the insert can no longer be cleaned
properly, replace the complete silencer
unit.
1.6.2 Checking, setting and adjusting
the V-belt tension
Checking V-belt tension:
See instruction manual, part 2.
GB
UNM STS 5,5 kW
II/1