Zodiac Baracuda MX 8 Guide Du Propriétaire page 8

Operation and Routine Maintenance
The Baracuda ® MX™ 8 cycles on/off with the pool filtration pump, vacuuming and cleaning all surfaces
randomly throughout the pool. The climbing ability of the cleaner is dependent on the pool's shape and
available water flow. If Baracuda MX 8 is not climbing your walls, ensure the flow is correct by using the
Flow Gauge. Also, ensure the pools surface is not covered in algae as this slippery surface will affect
the cleaner's traction.
During each coverage pattern cycle, the cleaner travels both forward and backwards, and pivots to the
right and left. The power scrubbers underneath the cleaner create down force for climbing and stability
as well as directing debris into the cleaner mouth.
Emptying the Pump Basket
For the Baracuda MX 8 to operate at optimum efficiency, empty the pump basket regularly. The more
debris in the pool, the more often the pump basket should be cleared. Zodiac offers an in-line leaf
®
canister which will trap solid debris before it enters the pump basket. See your Zodiac dealer for details.
Backwashing the Pool Filter
Always disconnect the Baracuda MX 8 from the pool wall before cleaning or backwashing the pool filter.
After cleaning or backwashing, let the filtration system run for at least five (5) minutes to flush out the
suction lines before re-connecting the cleaner.
Adding Chemical to the Pool
Remove the cleaner from the pool for at least four (4) hours when adding chemicals.
Storage and Winterizing
Never store the Baracuda MX 8 in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered by the warranty). Remove all connectors and adapters from the
dedicated suction line or skimmer. When storing the cleaner, even for short times, do not coil the hose
as the hose may develop a memory which can affect cleaner performance. Disassemble the hoses and
layout flat.
8 8