Epson TM-H5000II Manuel D'utilisation page 8

English
4. Turn the cassette knob on the
cartridge in the direction of the
arrow 2 or 3 times to remove
any slack.
5. Insert the ribbon, and rotate the
cassette knob 2 or 3 more times,
as shown in illustration
6. Make sure the ribbon has no
wrinkles or creases and is installed below the print head as
shown on the label inside the printer.
Installing the Roll Paper
1. Press the button, as shown in illustration
2. Insert the roll paper as shown in illustration
is inserted correctly as shown in illustration
4
3. Pull out a small amount of paper, close the cover, and tear off
the paper.
Inserting Slip Paper
Note:
Do not use wrinkled or curled paper.
1. When the SLIP LED flashes, insert slip
paper, using the right edge of the slip
paper inlet as a guide (see illustration
2. When you insert the slip into the inlet as
far as it will go, the sensor detects the
slip, the SLIP LED changes from flashing
to on, and the printer draws the paper in
and prints it.
3. After printing is complete, the SLIP LED
goes off, and you can remove the slip.
Note:
An optional front extension table (WT-5000) is available for users who
need it to enable handwriting on paper or other uses.
8 TM-H5000II User's Manual
3
.
3
5
).
7
, to open the cover.
4
. Make sure that it
5
.
6
6
2
7
1