Joie Mimzy highchair Manuel D'instructions page 6

WARNINGS
!
Adult assembly required.
!
Please read all the instructions in this manual before assembling and using this product.
!
Please keep instruction manual for future reference.
!
This product is suitable for children between 6-36 months of age (under 15kg).
!
Failure to follow these warnings and the assembly instructions could result in serious injury or death.
!
DO NOT make any modification to this highchair or use it along with component parts from other
manufacturers.
!
DO NOT use the highchair if any parts are broken, torn or missing.
!
DO NOT use the highchair unless all components are correctly fitted and adjusted.
!
DO NOT leave child unattended. Always keep your child in view.
!
To prevent serious injury or death from falling or sliding out, always secure child in the restraint.
!
Follow these instructions carefully to make sure the restraint harness is fitted correctly.
!
Secure your child at all times using the restraint harness provided in both the reclining or upright positions.
The tray is not designed to hold your child in the product.
!
DO NOT use the highchair until the child can sit up unaided.
!
It is recommended that the product be used in the upright position only by children capable of sitting
upright unaided.
!
DO NOT allow your child to stand in or on the highchair.
!
DO NOT lift and carry highchair while occupied.
!
DO NOT allow children to play with or around highchair while occupied.
! DO NOT allow children to lean over sides of highchair. It may become unbalanced and tip over.
!
DO NOT place any heavy bags, packages, or other items on the highchair tray. They may cause the chair to
tip over.
!
Always use on a flat and level floor.
!
Be aware of the risk of open fire and other sources of strong heat such as electric bar fires, gas fires etc.
in the vicinity of the highchair.
!
To avoid strangulation hazard, DO NOT place product in any location where there are cords, such as
window blind cords, drapes, phone cords, etc.
!
All assembly fittings should be unfolded completely, tightened and latched properly before using
the product.
!
Regularly check the locks and fittings for security.
!
Regularly inspect the product for damaged hardware, loose joints, missing parts or sharp edges.
!
Remove your child from product before folding or adjusting the highchair.
!
Make sure the product has been folded or unfolded completely before letting your child approach
the highchair.
!
Consult your local distributor for issues concerning maintenance, repair and part replacement.
!
To avoid burns, DO NOT place hot food on tray.
9
Highchair Assembly
Please read all the instructions in this manual before assembling and using this product.
Open Frame
1. Rotate rear leg back until an audible "click" is heard.
Assemble Seat
1. Open the seat. 2
3
2. Fit the seat onto the frame . An audible "click" means the seat is secured to the frame.
!
Lift the seat up to be sure it is locked into place.
Assemble Seat Pad
Assemble the seat pad by following these steps:
1. Open the seat.
2. Insert the two straps through openings in seat back.
!
Please make sure the straps are secured to the seat back to prevent the seat pad from slipping.
3. Pull all the harnesses through the slots in seat pad.
4. Wrap the seat pad over the top of seat back.
Highchair Operation
Adjust Calf Support
1. The calf support has 2 position settings.
2. Press the adjustment buttons on both sides of the seat
- 2
or upward. 7
Adjust Footrest
1. The footrest can be adjusted to 3 positions.
2. To adjust the footrest, remove the footrest from the calf support
then reinsert the footrest into the calf support.
Use Buckle
Note
1. To prevent serious injury or death from falling or sliding out, always secure child in the restraint.
2. Make sure the restraint harness is fitted correctly and the space between the harness and the
child does not exceed the thickness of an adult hand.
3. DO NOT cross the shoulder belts. This will cause pressure on child's neck.
Lock Buckle
Match the waist belt buckle up with the shoulder buckle and slide together
- 2
center buckle . A "click" means the buckle is locked completely
10
1
4
5
6
7 - 1
and rotate the calf support downward
8 , choose a desired position, and
9
- 1
10 . Insert buckles into the
- 3
. Repeat for other side.
10
10