Publicité
Les langues disponibles
Les langues disponibles
Maintenance
ATTENTION! Before performing any maintenance operation,
isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Cleaning the glass vapour screen (available only in some
models)
Fig. 12
The glass be dismounted and cleaned using a normal glass
detergent.
Instructions for removing the glass:
1.
Remove the grease filter.
2.
Lightly push the glass downwards and allow it slide
forwards.
3.
Remove the glass allowing it to rotate slightly.
After cleaning, follow the instructions in reverse to remount the
glass.
Grease filter
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. When washed
in a dishwasher, the grease filter may discolour slightly, but
this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Fig. 9
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
2 charcoal filters are required for cooker hoods with 2 motors
and 1 charcoal for cooker hoods with 1 motor.
The saturation of the activated charcoal occurs after more or
less prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths.
The carbon filter may NOT be washed or regenerated.
Fig. 10
Place the carbon filter in order to cover the protection grill for
the motor fan wheel, then turn the central handle P of the filter
clockwise.
To dismount the central handle P of the filter turn the handle
anti-clockwise.
Replacing lamps
Fig. 11
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Access the lamp housing area:
remove the lamp holder using a small screwdriver or similar
tool as a lever.
Replace the damaged light bulb.
According to the model you have:
Use plain candle lamps 40W max (E14) or halogen lamps
20W max (G4 12V)
Then close the lamp housing (snap lock).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
12
Publicité
