SPIT 160 SD Notice D'emploi Et D'entretien page 6

TECHNICAL SPECIFICATIONS
Nominal voltage
Power drain
Rated current
Frequency
Max. dry drilling Ø
Max. wet drilling Ø
Shank
Protection class I
Weight
Dimensions
Interference suppression according to
Gear / speed
1st speed
2nd speed
3rd speed
Collar fixation
2 water inlets
Electrical overload protection with LED
Mechanical overload clutch
Thermal overload protection
Noise and vibration
The indication of noise emission is measured after DIN 45 635, p art 21.
The level of acoustic pressure on work site could exceed 85dB (A); in this case ear
protectors must be used.
The typical hand-arm vibration is below 2.5 m/s².
Confirmation declaration
We declare in sole responsibility that the product type Spit SD 160 referred to in this
declaration conforms to the following standards and further normative documents.
We declare under our sole responsibility that this product is in conformity with the
following standards or standardization documents:
EN 60 745, EN 55 014, EN 61 000,
according to the regulations 73/23/EWG, 2004/108/EG, 2006/42/EC
Paul van Beek
General Manager
3
230 V
2000 W
9.25 A
50-60 Hz
181 mm
131 mm
½" and 1 ¼"
6.2 kg
405 x 265 x 112 mm
EN 55014 and EN 61000
Idle speed Load speed
0-660 rpm 0-900 rpm
0-1550 rpm 0-2200 rpm
0-3300 rpm 0-4600 rpm
60 mm
¼"
ITW Heger
Industriepark
Cardijnlaan 3
BE-8600 Diksmuide
Belgium
Ruben Bernaert
Product Manager