Operation Keyboard - Orlaco DDIN Mode D'emploi

Software Version : 2.1.6
Update 2.1.0  2.1.6 : Debugging, customer specific requirements
implemented.
This section describes the basic (R)LCD monitor operation using
the front panel buttons. All settings made on the front panel can
also be adjusted in the service menu.

Operation keyboard

1. Camera selection
Press the camera button once. The camera LED will blink, indicat-
ing that the manual camera override is active. Use the plus and
minus buttons to select the camera. It is possible to use the other
controls (brightness, contrast and saturation) and to tune these
settings with the plus and minus button. You can select a different
camera by switching off this function by pushing the plus and
minus. The manual camera selection has priority over the scan
function and the switching wires. The button function can be disa-
bled in the service menu by selecting the option 'system settings
 keyboard  keyboard lock.' See also 'Service menu operation'
below for further explanation.
2. Auto (R)LCD Backlight Control/Day/Night settings
Push this button to switch between the ABC modes, the (R)LCD
backlight day and the (R)LCD backlight night settings. The ABC
mode controls the backlight settings between minimum settings
(adjustable, see service menu) and 100%, depending on the
amount of available ambient light. The day and night modes
brightness settings can be manually adjusted by pushing the
plus or minus button (settings will be saved). This setting is not
camera specific and will therefore function on all cameras.
3. Contrast adjustment
Press contrast once to enter contrast adjustment mode. Now
use the plus and minus buttons to select the image contrast.
4. Brightness adjustment
Press brightness once to enter brightness adjustment mode. Now
use the plus and minus buttons to select the image brightness.
3. and 4. Saturation adjustment
Press contrast(3) and brightness(4) at the same time to enter
saturation adjustment mode. Now use the plus and minus but-
tons to select the image saturation.
Blocking of 2.3.4.
The operation off these buttons can be disabled in the service
settings menu.
5. Single sequence scan
When pushed button 5 'option' the (R)LCD generates a single
sequence scan (not continuous) of the attached cameras (using
whatever dwell time was programmed, see page 7)
UM0208201 R3-5
Usermanual
objects in
monitor are
closer than
they appear
Buttons 1 2 3 4
Button No. 1 = Camera selection
Button No. 2 = Auto (R)LCD Backlight
Control/Day/Night settings
Button No. 3 = Contrast
Button No. 4 = Brightness
Button No. 5 = Option
Button No. 6 = Selection/setting -
Button No. 7 = Selection/setting +
Button No. 8 = Enter
5 6 7 8
3