Husqvarna ROYAL 43EL Manuel De L'utilisateur page 10

Cable Restraint
1. Form loop in mains
cable and push the
loop through the
slot as illustrated in
picture F1.
2. To secure, position
loop over the hook
and pull the cable
back through the
slot as illustrated in
picture F2.
Starting the
lawnmower
• The switchbox is
provided with a
lock-off button
(G1) to prevent
accidental
starting.
1. Press and hold the
lock off button on
the switchbox,(G1)
then squeeze the
Start/Stop lever
towards the upper
handle (G2).
2. Continue to
squeeze the
start/stop lever and
release the lock-off
button (G3).
English - 5
STARTING AND STOPPING
F1
F2
G1
G2
G3
ROYAL 43ELS (H)
Engage the clutch by
squeezing the clutch
lever towards the
handle.
Adjusting the Clutch Cable Royal
43ELS only
1. Ensure the cable is not twisted and
runs freely down the handles.
2. Loosen locknut (J1) and screw
adjuster (J2) "IN", in the direction
of the arrow, if clutch does not
engage when the clutch lever is
pulled towards the handle.
3. Screw adjuster (J2) "OUT", in the
opposite direction from the arrow, it
the clutch lever does not
disengage when the the clutch
lever is free.
4. Tighten locknut (J1) finger tight
then 1/4 turn with a spanner.
J
Stopping the lawnmower
1 Release the pressure of the Start
/Stop lever
H
ROYAL 43ELS
1
2