Description Of Terminals, Connectors And Jumpers; Wiring Instructions; Speaker Volume Adjustment - Urmet MIKRA 2 Notice D'installation

3.2 DESCRIPTION OF TERMINALS AND JUMPERS
Terminal board
+ Positive terminal for local power supply
-
Negative terminal for local power supply

4 WIRING INSTRUCTIONS

• Remove the insulation sheath of the CAT5 cable (with rigid wires) for at least 40mm.
• Strip the conductors for no more than 6mm.
• Insert the wires in the connector respecting the positions and colour codes shown (Standard T568B).
1
• Proceed as shown below if a wire needs to be removed from the connector:
Refer to the instructions contained in the system manual for maximum distances and confi guration
operations.

5 SPEAKER VOLUME ADJUSTMENT

For information on sound levels settings, refer to the system manual.
10
8
1
2
Wire No.
1 White-Orange
2
3
4
5
6
7
8
1
Wire colour
Orange
White-Green
Blue
White-Blue
Green
White-Brown
Brown
2
DS1060-134A