Assembly; Operation - Husqvarna 120iTK4-H Manuel D'utilisation

Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the shaft
1. Make sure that the electrical plugs are aligned.
A
2. Connect the ends of the shaft (A) fully.
3. Tighten the screw handle on the hedge trimmer head
side of the shaft (B).
To adjust the length of the shaft
1. Loosen the screw handle at the battery housing side
of the shaft (A).
A
Introduction
WARNING:
safety chapter before you use the product.
1637 - 003 - 06.04.2021

Assembly

Read and understand the
B
B

Operation

Read and understand the
2. Adjust the shaft to an applicable length.
3. Tighten the screw handle (B).
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is roughly level with your right hip.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
11