Preparing The Appliance For Operation; Oscillation Function / Swing Function - Unold 86585 Notice D'utilisation

PREPARING THE APPLIANCE FOR OPERATION

1. Comply with all safety instruc-
tions and safety regulations.
2. Ensure that you have selected a
safe location.
3. Plug the mains plug of the appli-
ance into an electrical outlet
(220–240 V~, 50 Hz).
4. Press the ON/OFF button on the
top of the appliance.
5. A short signal tone will sound.
6. Now press the power button on
the top of the appliance or the
"ON/OFF" button on the remote
control unit.
7. The symbol
button is shown in the display to
indicate that the appliance is in
operation.
8. Likewise, the symbols
"Low heating output" of both
heating elements and the plant
symbol
ture, also appear in the display.
Caution: The following explana-
tions apply for adjustment on the
control panel itself, and via the
remote control unit. The button
designation is identical in each
case.
9. Via the "Heater 1" and "Heater
2" buttons you change between
the "Low" and "High" modes for
each heating element.
10. The selected operating mode will
be shown via the appropriate sym-
bols in the display:
High
Low

OSCILLATION FUNCTION / SWING FUNCTION

1. With this function it is possible to
distribute the air flow over a lar-
ger area, because the appliance
swings back and forth in a speci-
fic radius.
2. The oscillation function can be
switched on in every mode. To do
for the Power
for
for room tempera-
11. Via the symbols, the display shows
which heating elements are active
and the power with which they are
active.
12. Press the "Temp/Timer" button to
change between the desired room
temperature and the time preset.
13. To set the desired room tempera-
ture, press the Temp/Timer button
until the following is shown in the
display
Now use the "+" and "-" buttons
to select the desired room tempe-
rature between 15°C and 35°C.
Confirm the entry by pressing the
Temp/Timer button again.
14. To select the desired operating
time, press the Temp/Timer but-
ton until
0
H
the + and – buttons to select the
desired time between 1 and 12
hours. Confirm the entry by pres-
sing the Temp/Timer button again.
15. The set values will also be stored
when the appliance is switched
off.
16. To switch off the appliance, press
the power button and switch off
the appliance via the ON/OFF
switch. Then unplug the mains
plug from the electrical outlet.
Be aware that the appliance
can become very hot - danger
of burns! Particularly ensure
that children are kept away
from the appliance.
this, press the "Swing" button.
If you want to stop the appliance
in a specific position, press the
"Swing" button again.
3. Switch off the oscillation function
before you switch off the appli-
ance.
is displayed.
is displayed. Now use
23