Installing The Camera; Mounting The Camera; Adjusting The Focus, Iris And Zoom - Sony SNC-VL10P Guide De Référence Rapide

Installing the
Camera

Mounting the Camera

To attach the camera to a tripod, mounting
bracket, suspension bracket, etc., use the
appropriate screw (U1/4", 20 UNC) that fits
the installation/tripod hole on the bottom of
the camera.
The following mounting screw can be used.
ATTENTION
If installing the camera on the ceiling, be
sure it is secure. If not securely installed, the
camera may fall and injury may occur.
If the camera is installed on the ceiling using
equipment such as a bracket, housing and
motored swivel base (pan/tilt), do the
following:
• Use a tripod screw and securely tighten it
with a screwdriver. Order the tripod screw
(Sony Part No. 3-174-693-01) from your
nearest Sony dealer.
• Install the camera on a flat surface.
14
GB

Installing the Camera

U1/4", 20 UNC
= 4.5 mm ± 0.2 mm
(ISO standard)
Adjusting the Focus, Iris and
Zoom
After mounting the camera, aim the camera
at an object and adjust the focus, iris and
zoom.
For these adjustments, we recommend using
the output signal from the VIDEO OUT
connector of the camera.
AC power adaptor
(supplied)
Power cord
(supplied)
to an AC outlet
Video monitor, etc.
1
Remove the lens cover from the
camera.
SNC-VL10P
VIDEO
OUT
DC IN
12 V
Composite
video input