Connecting The Router; Configuring The Router As An Access Point - Eminent EM4543 Mode D'emploi

Install the router as an access point if you have a router or DSL modem router. Make
sure that your Internet browser and your network are well configured when configuring
manually. You can assume that the settings are correct, unless you have changed any
of the settings in the past.
Example of EM4543/EM4544/EM4571 as an Access Point

5.1 Connecting the router

1. Turn off the computer.
2. Connect the router to a wall outlet using the supplied power adapter.
3. Connect the supplied UTP network cable to the 'LAN 4' port of the router.
4. Connect the other end of this UTP network cable to the network adapter of your
computer.
Is my router correctly connected to the wall outlet? You can check this by verifying that
the POWER LED is on.
Do I have a proper network connection? Turn on the computer and verify if the LED on
the router, corresponding with the LAN-port to which you connected the UTP
networking cable, is lit. The LED on the network adapter of your computer should also
be lit..

5.2 Configuring the router as an Access Point

Before you can configure the router for an Internet connection you first need to
connect to the router by following the procedure below.
1. Turn on your computer.
2. Open your webbrowser (e.g. Internet Explorer or Firefox).
3. Type 'http://192.168.8.1' in the address bar.
4. Press the 'Enter key' or click 'Go to'.
11 |
ENGLISH