Adjusting The Lcd Panel Angle; Inserting/Ejecting/Connecting Media; On First-Time Startup - Pioneer AVH-X5700BHS Mode D'emploi

Basic operation
that angle for safety.
●
Do not place a glass or can on the open LCD panel.

Adjusting the LCD panel angle

X4700BS
X5700BHS
1 Press the button.
2 Touch or to adjust the angle of the
LCD panel.
3 Touch .
Returns to the previous screen.
Inserting/ejecting/connecting
media
CAUTION
Do not insert anything other than a disc into the disc-loading
slot.
Inserting and ejecting a disc
Inserting a disc
X4700BS
X5700BHS
1 Press the button.
2 Touch to open the LCD panel.
3 Insert a disc into the disc-loading slot.
Ejecting a disc
X4700BS
X5700BHS
1 Press the button.
2 Touch to open the LCD panel.
3 Remove the disc, and press the
Inserting a disc
X3700BHS X2700BS X1700S
 Insert a disc into the disc-loading slot.
Ejecting a disc
X3700BHS
 Press button to eject a disc.
Plugging and unplugging a USB stor-
age device
p This product may not achieve optimum performance with
some USB storage devices.
p Connection via a USB hub is not possible.
p A USB cable is required for connection.
1 Pull out the plug from the USB port of the USB
cable.
2 Plug a USB storage device into the USB cable.
1 USB cable
2 USB storage device
Check that no data is being accessed before pulling out the
USB storage device.

On first-time startup

1 Start the engine to boot up the system.
After a short pause, the splash screen comes on for a few
seconds.
The "Select Program Language" screen appears.
p From the second time on, the screen shown will differ
depending on the previous conditions.
2 Touch the language that you want to use on
screen.
button.
3 Touch .
The "Speaker Mode Setting" screen appears.
4 Touch the speaker modes that you want to use.
●
Standard Mode
X2700BS X1700S
1
2
4-speaker system with front and rear speakers, or a
6-speaker system with front and rear speakers and
subwoofers.
●
Network Mode
2-way+SW Multi amp, multi-speaker system with high
speaker, mid speaker and subwoofer for reproduction of
high, middle and low frequencies (bands).
WARNING
Do not use the unit in standard mode when a speaker system
for 3-way network mode is connected to this unit. This may
cause damage to the speakers.
5 Touch [OK].
The "Smartphone Setup" screen appears.
6 Touch the item you want to set.
 Information on the connections and functions for each device
on page 17
7 Touch .
The top menu screen appears.
p Once the speaker mode is set, the setting cannot be
changed unless this product is restored to the default
settings. Restore the default settings to change the speaker
mode setting.
 Restoring the default settings on page 48
Switching the speaker mode
 Restore the default setting.
 Restoring the default settings on page 48
9