Panasonic Technics SU-R1000 Mode D'emploi page 25

Before requesting service, make the following checks. If you are uncertain about some
of the check points, or if the solutions indicated in the following guide do not resolve
the issue, then consult your dealer for instructions.
Heat buildup of this unit
This unit becomes warm while in use. This is not
a malfunction.
Do you have the latest firmware
installed?
Panasonic is constantly improving the unit's
firmware to ensure that our customers are
enjoying the latest technology. ( 23)
To restore all settings to the factory
defaults
When the following situations occur, reset the
memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory
contents.
1 Press [SETUP].
2 Press [ ], [ ] repeatedly to select
"Initialization" and then press [OK].
• A confirmation screen appears. Select "Yes"
in the following steps to restore all the
settings to defaults.
3 Press [ ], [ ] to select "Yes" and then
press [OK].
4 Press [ ], [ ] to select "Yes" and then
press [OK] again.
Troubleshooting
General
The unit does not work.
Operations are not done properly.
• One of the unit's safety devices may have been
activated.
Press the unit on/off button to the [
position.
• If the unit does not switch to standby,
disconnect the AC mains lead, wait for at
least 3 minutes, then reconnect it.
Press the unit on/off button to the [
position. If the unit still cannot be operated,
consult the dealer.
A "humming" sound can be heard during
playback.
• An AC mains lead of another device or
fluorescent light is near the cables. Turn off
other appliances, or keep them away from the
cables of this unit.
• A strong magnetic field near a TV or other
device may adversely affect the audio quality.
Keep this unit away from such a location.
• The speakers may output noise when a device
nearby is emitting powerful radio waves, such
as when a mobile phone is on a call.
No sound.
• Check the volume of this unit and the
connected device.
• Check connections to speakers and other
equipment.
• Connect speakers and measure the output
signal of the amplifier. ( 22)
• Check the impedance of the connected
speakers.
• Check to see if the correct input source is
selected.
• Insert the plugs of the cables to be connected
all the way in.
• Confirm the sound output setting. (Sound is
not output from the speakers connected to the
speaker output terminals of this unit while "PRE
OUT" is set to "Off".) ( 19)
• Sound is not output from headphones jack and
REC OUT/PRE OUT terminals.
• Playback of multi-channel content is not
supported.
• The digital audio input terminals of this unit can
only detect linear PCM signals. For details, refer
to the operating instructions of the device.
Settings / Troubleshooting
]
]
25
(25)