Speaker Preparation - Sharp HT-SB300 Mode D'emploi

Speaker preparation

Make sure to unplug the AC power lead before installing
the speaker or changing the position.
Select from three installation methods acleading to the preferred
position.
Using spikes
You may choose from the two different spike lengths provided:
25 mm and 30 mm.
Nuts (secured on 30 mm spikes) must be used when installing
either the 25 mm or 30 mm spikes.
The speaker can be levelled by adjusting the spikes and nuts.
Notes:
Option 1 or option 2 indicates spike positions based on LCD
TV stand.
When attaching the spikes, place the speaker on a cushion or
soft cloth to avoid damage.
Option 2
Option 1
Tighten all spikes as shown
Caution:
When using these spikes on glossy or slippery table such as on
glass top, stick foot cushions at the bottom of the spikes to avoid
slippage.
Using foot cushions
Note:
Option 1 or option 2 foot cushion positions based on LCD TV
stand.
2009 February 10
Option 2
Option 1
Attach foot cushions as shown
HT-SB300_A6_EN_UK.fm
HT-SB300
ENGLISH
E-6