Network Configuration - Ebode IPV38 Guide Utilisateur

1.7.3 Network Configuration

Below shows how you can configure the Network parameters.
Obtain IP from DHCP server: If clicked, the device will obtain IP from DHCP server. In other words, the camera will have a
dynamic IP. (Make sure the Router which the camera connects to has DHCP function and DHCP is enabled, by factory
default all routers have DHCP enabled). (Figure 2.2).
IP address: Fill in the IP address assigned and make sure it is in the same subnet as the Gateway, and the subnet should
be the same as your computer or router. (I.e. the first three sections are the same).
Subnet Mask: The default subnet mask of the equipment is: 255.255.255.0.
Gateway: Make sure it is in the same subnet with PC's IP address .Here gateway is the LAN IP of your router.
DNS Server: IP address of IPS network provider. We suggest you use the same IP address as the Gateway.
Jul 2013
Figure 2.2
Figure 2.3
13 IPV38 / IPV38WE