Six Options Available - Ebode IPV38 Guide Utilisateur

No IP Cameras found within LAN. After about 1 minute search, the Result Field will show "not found IP Server" and
1.
the program shut down automatically.
2. IP Cameras have been installed within LAN. All the IP Cameras will be listed and the total number is displayed in the
result field as shown in Figure 1.9.
3. The IP Cameras installed within LAN do not share the same subnet with the monitoring PC. A prompt will be shown
in result field (prompt: Subnet doesn't match, double click to change!). Click the left mouse button to choose the
prompt and click the right mouse button, choose Network Configuration to set the static IP address of the Camera to
the same subnet as your LAN. (Figure 2.3).
NOTE: If it shows" Subnet doesn't match, double click to change!" you can also choose "Obtain IP from DHCP Server" to
get a dynamic IP. (Figure 2.2). If the camera still doesn`t show in the IP Camera Tool please use the Reset button on the
bottom of the camera and hold it for 15 seconds with the power on. (Figure 1.3)
Please be sure your computer is on the same network as the camera !
Mac Users:
Browse to the Mac folder x:\ebode IP Vision software\IP Camera Tool.app\Contents and install the IP Camera Tool.

1.7.1 Six Options Available

Choose the IP Camera and Click the right mouse button on that camera, there are six options: (Figure 2.0). Basic
Properties, Network Configuration, Upgrade Firmware, Refresh Camera List, Flush Arp Buffer, About IP Camera Tool.
Jul 2013 11 IPV38 / IPV38WE