Publicité
Les langues disponibles
Les langues disponibles
Installing the wire guard
NOTICE:
Do not expand the wire guard outward
too much. Otherwise it may break.
To reduce the risk of damaging the objects in front of the
cutting head, attach the wire guard to the protector so
that it controls the cutting range.
Slightly expand the wire guard outward and then insert
it into the holes of the protector.
Attach the wire guard to the holes on the front side of
the protector. The nylon cord mark on the protector
indicates the hole to be used.
1
► 1. Hole
When wire guard is not in use, lift it for the idle position.
► 1. Wire guard
Installing the protector
CAUTION:
careful not to contact the nylon cord cutter on
the protector. Contact with the cutter could result in
personal injury.
2
► 1. Screw 2. Protector
Mount the protector by fitting it on to the motor housing,
and then secure it with two screws.
Installing nylon cutting head
Optional accessory
CAUTION:
tally impacts a rock or hard object during oper-
ation, stop the tool and inspect for any damage.
If the nylon cutting head is damaged, replace it
immediately. Use of a damaged cutting tool could
result in serious personal injury.
CAUTION:
after installation.
CAUTION:
nylon cutting head, be careful not to contact the
nylon cord cutter on the protector. Contact with the
cutter may result in personal injury.
NOTICE:
cutting head.
1.
Turn the tool upside down so that you can replace
the cutting tool easily.
1
9 ENGLISH
While installing the protector, be
1
If the nylon cutting head acciden-
Be sure to remove the hex wrench
When installing or removing the
Be sure to use genuine Makita nylon
Publicité
