Publicité
Les langues disponibles
Les langues disponibles
NOTICE:
Do not force the trimmer in densely
growing grass.
NOTICE:
Do not use the trimmer as if you dig out
the ground.
Cutting the grass near tree, block,
brick, or stone
Hold and tilt the grass trimmer at a height where the
spool does not touch the ground. Cut the grass using
the nylon cord tip like knocking the ground.
NOTICE:
When cutting the grass, move the
grass trimmer around the tree or blocks so that
the nylon cord does not touch the tree or blocks.
It is recommended to keep the tool more than 5 cm
(1/4") away from the tree or block. If the nylon cord
touch the tree or block, the nylon cord may be torn. If
the nylon cord is torn in the spool, set the nylon cord
again referring to the replacement procedure in this
manual.
Using the grass trimmer as an edger
Using the grass trimmer as an edger is suitable for
cutting the grass growing along the bricks or blocks.
Pull down the wire guard and rotate the grass trimmer
180°.
As shown in the figure, while contacting the wire guard
with the ground, move the grass trimmer to cut the
grass. You can cut the grass efficiently by walking in
parallel along the bricks or blocks.
► 1. Wire guard
11 ENGLISH
1
Publicité
