Important; Cleaning; Storage - Philips HR2380 Mode D'emploi

ENGLISH
10

Important!

The pasta recipes provided in the recipe book have been tested for success. If you
experiment with or use other pasta recipes, the flour and water/egg ratios will need to
be adjusted. The pasta maker will not operate successfully if you do not adjust the new
recipe accordingly.
Note
y To ensure the quality of the pasta, use gluten flour to make pasta. Follow the
recommended proportion to add the ingredients.
y Seasonal changes and using ingredients from different regions may affect the
flour/water ratio. You may adjust based on the recommended proportion.
y When making egg pasta or vegetable pasta, make sure you whisk the egg mixture
or vegetable juice evenly with the water before pouring into the chamber through
the slot in the lid. When adding ingredients, make sure the ingredient is in a liquid
form.
y See the recipe book provided for additional pasta recipe variations.
y When making gluten free pasta/noodles or cookies, do not follow the
recommended liquid amount indicated by the appliance.

Cleaning

1 Disconnect the plug from the power outlet.
2 Remove the mixing chamber lid. (Fig. 3)
3 Loosen the front panel control knobs. (Fig. 4)
Note: The front panel is heavy. Take extra caution when removing it.
4 Disassemble the front panel, the shaping disc, the shaping disc holder, the mixing
paddle, and the mixing chamber in order. (Fig. 5)
5 Use a dry cloth to clean flour residue on the main unit. (Fig. 29)
6 Clean the shaping disc with the supplied cleaning tool to remove the dough residues.
After that, you can clean it with water. (Fig. 30)
Note: For the spaghetti, thick spaghetti, angel hair and fettuccine shaping discs, let
the discs air-dry 2 to 4 hours. Then use the corresponding cleaning tool to poke out
the dough in the holes.
7 Clean all detachable parts, and wipe them dry. (Fig. 6)
8 Use a dry cloth to clean the control panel, and the exterior of the pasta
(Fig. 31)

Storage

1 Unplug the appliance and let it cool down.
Note: Make sure all parts are clean and dry before storing.
2 You can store the shaping discs in the storage drawer. (Fig. 32)
(Fig. 28)
maker.