Dimas FS 350 C-03 Manuel D'utilisation page 26

11 Engine belt tension
• This saw is equipped with high tensile V-belts.
Belts are properly tensioned at the factory.
• To obtain accurate V-belt setting, a V-belt
tension tester should be used. Apply load at the
center of the belt span. Deflection should be 1/5"
with a 5 to 6 pound load.
After several hours of use it may be necessary to
adjust the tension of the belts (moderately). To do
this proceed as follows :
Release the screws fixing the motor to the
chassis.
Turn the tensioning screw (N) at the front of
themachine one quarter turn; this screw
pushes the motor backwards [
At normal tension, counterlock the nut of the
screw (N).
Relock the motor fixing screws.
Never set belts beyond original
tension
12 Important advice
• Periodically tighten all nuts and bolts, particularly
after the first few hours of operation.
• Check the tension of the belts. Tighten them, as
instructed.
• When storing the machine, we recommend
removing the blade and storing it carefully.
• Check that the blade is properly sprayed by
inspecting the holes in the fork regularly.
• Tighten the blade firmly.
• Make sure the contact faces of flanges, blade
and axle are clean.
The
responsibility for loss or damage
resulting
modification, alteration or powering
that does not conform to the
manufacturer's original specifications.
At the work station, the sound
pressure level may exceed 85 db (A)
In this case individual protection
24
measures must be taken.
6].
FIG.
manufacturer declines
from misuse
13 Repairs
S
A
V
14 Spare parts
For quick supply of spare parts and to avoid any
lost time it is essential to quote the data on the
manufacturer's plate fixed to the machine and the
part number of the part to be replaced with every
order.
Item number
15 Scrapping
• Main materials :
Motor : Aluminium (AL), Steel (AC),
Motor :
Machine : Steel sheet (AC), Cast iron (FT)
Machine :
all
or any
The instructions for use and spare parts found in this
document are for information only and are not binding.
As part of our product quality improvement policy, we
reserve the right to make any and all technical
modifications without prior notice.
When working in a limited or closed
area, make sure that the ventilation is
adequate. The exhaust gases contain
carbon monoxide (exposure to this
toxic gas can cause
consciousness and can be fatal).
We carry out all repairs in the shortest
possible time and at the most
economical prices (see overleaf for our
address).
00000000 (0)
See exploded view
In the event of deterioration and
scrapping of the machine, the
following items must be disposed of
in accordance with the requirements
of the legislation in force.
Copper (CU), Polyamide (PA)
Aluminium (AL)
loss of
Quantity