Electrical Safety - Dimas FS 350 C-03 Manuel D'utilisation

• Petrol engine machine (consult the engine
maintenance manual)
Take into account the working conditions
from health and safety point of wiew.
Check that the fuel tank is full.
Check that the engine oil level is correct. As
the engine often operates at an angle, check
the oil level (with the engine horizontal)
frequently to ensure that it never falls below
the second mark on the dipstick.
For starting up refer to the engine handbook.
• M a c h i n e w i t h e l e c t r i c m o t o r. Check the
following:

- ELECTRICAL SAFETY :

Operate this machine only on a
supply equipped with a 30 mA
earthed current-limiting circuit-
breaker. Otherwise, consult our
catalogue for appropriate models.
- The RCCB must be used correctly,
including testing it regularly. For
t o o l s s u p p l i e d w i t h a n i n t e g r a l
RCCB in the cable or in the mains
plug, if the cable or plug has been
damaged, repairs must be carried
out by the manufacturer, one of
his agents or by a qualified repair
w o r k s h o p t o a v o i d a n y r i s k s
resulting from errors.
Motor power supply: reinforced electric cable
with 4 (3P+E) or 5 (3P+N+E) conductors 2.5
mm 2 for lengths less than 100 m.
Earthing of the machine (mandatory).
Mains voltage (400 V).
Direction of rotation of the motor : Direction of
rotation on the right hand side of the cover (if
the motor does not turn in the direction
required, reverse two of the supply wires.
6 Fitting the blade
Motor off
Disconnect by removing the plug.
22
• Set the machine in the high position.
• Disconnet the water pipe from the blade guard.
• Unscrew the nut (K) from the guard [
• Lift up guard (A).
• Fit the diamond blade.
Take care about the direction of rotation
which is shown by an arrow on one of
the faces (direction of rotation on the
right side of the guard)
Make sure the contact faces of flanges
(B and C), of blade and the axle are
clean
• Firmly lock screw (D) using the spanner supplied
with the machine whilst immobilising the blade by
hand.
• Replace the protection guard (A).
• Close the guard water tap (G) [Fig 4].
• Reconnect the water pipe (G).
• Tighten nut (K).
Replace all protective covers for your
safety and that of other persons.
7 Starting up
Danger: risk of injury
Always pay extreme care and attention
to the preparation of the machine
before starting up
Remove all adjustment tools and
wrenches from floor and machine
Always keep blade guard in place
• Fill the tank with water.
• Mark the floor by drawing a line in the place to be
cut.
• Fold down the front guide and position the
machine so that the guide (F) and the blade line
up with the mark.
Engine
Start the engine: refer to the instructions in the
manufacturer's service manual.
Allow the engine to warm up.
Electric motor
Switch on by pressing knob I on the circuit
breaker.
• Open the water inlet tap (G).
• Increase the engine speed to maximum.
3].
FIG.