Publicité
Les langues disponibles
Les langues disponibles
Receiver instructions
Each transmitter generates a code that must be "known" by a receiver in order to operate. Proceed to the next step to store
one or more transmitters in the receiver memory.
To learn a remote
1. Connect the power supply to the receiver unit (see page 2)
2. Hold 'setup' button, 'MODE'-led (8) turns on after a few seconds.
3. Press any remote control transmitter button.
4. 'CONFIRM'-led (10) lights when the code has been grabbed.
5. Release 'setup' button.
If neccesary repeat steps 2 to 5 to learn the codes for other transmitters.
31 transmitters can be stored. If memory is full, 'MODE' and 'CONFIRM' will flash simultaneously when 'setup' button is
pressed (see also next page to erase the memory).
The relay outputs can be set to different modes, from a simple on/of contact to a short or long timer.
Configuration of channel 1 'CH1' and channel 2 'CH2' :
1. Connect the power supply to the receiver unit (see page 2)
2. Push 'setup'-button repeatedly to select CH1 (left) or CH2 (right) output relay
3. Confirm with a long push ('CONFIRM' flashes 3 times). The selected relay will remain ON
4. Push 'setup'-button a number of times, depending on the desired mode (see table).
At each press, 'MODE' will flash a number of times, indicating the current mode
5. Confirm with a long push ('CONFIRM' flashes 3 times). The selected channel will turn off and
the unit is ready for use.
If necessary, repeat steps 2 to 5 for the remaining channel.
The unit returns to normal operation when left idle for 10s.
( Factory defaults: CH1: 1h timer, CH2: 0.5s pulse)
Receiver instructions
flashes
Mode
1
ON/OFF
2
0.5s
pulse
3
5s
timer
4
30s
timer
5
1min
timer
6
5min
timer
7
15min timer
8
30min timer
9
1h
timer
5
Publicité
