Gallagher B80 Mode D'emploi page 8

Step 2
Connect to earth (ground) system
Using Lead-out Cable G6270 remove 5cm (2") of plas c coa ng from one end of
the cable and a ach to the green terminal on the Energizer. A ach the cable to the
earth system by removing 10cm (4") of insula on from the cable at each Earth Stake,
then clamp the exposed wire to each stake using an Earth Clamp G8760. Tighten the
clamp.
For portable fencing – earth lead is provided.
Step 3
Connect the fence
Connect Energizer's red terminal to the fence
using Lead-out Cable G6270: remove 5cm
(2") of plas c coa ng from one end of the
cable and a ach to the red terminal on the
Energizer. A ach the other end of the cable to
the fence using a Joint Clamp G6030.
For portable fencing – fence lead is
provided.
Step 4
Connect the ba ery
Connect the ba ery leads from the
Energizer to the ba ery: red lead
to the (+) terminal of ba ery,
black lead to the (-) terminal
of ba ery. Use external 12V deep cycle lead acid rechargeable ba ery. Do not
use non-rechargeable ba eries. During charging, place lead acid ba eries in a
well-ven lated area.
Connect to Mains Power Adaptor
This symbol indicates that the separate power supply unit (G40101) was used to power
the Fence Energizer during tes ng. This symbol is located on the outside of the Fence
Energizer near the DC power entry inlet. Using a diff erent power supply unit may void the
approvals and standards met by the Fence Energizer.
8
Gallagher 3E0917 B80 B180 B280 Portable Fence Energizer
To earth
(op onal accessory G40101)
Red
Green
To ba ery
To fence