Product Overview; Operation; Before Use; Connecting The Device - AEG 10269 Mode D'emploi

16 www.aeg-automotive.com
ProDucT
oVerVIeW
7
6
5
4
3
No. Description
1 leD 1 "25 % display"
2
leD 2 "50 % display"
3
leD 3 "75 % display"
4
leD 4 "100 % display"
5
charging cable (-) with charging clamp (black)
6
charging cable (+) with charging clamp (red)
7
Power cable with plug
1
2

oPeraTIon

Before use

Warning!
before using this device be sure to read the ope-
rating manual for the battery and the vehicle and
understand all safety notices�
•
use safety goggles and acid-proof safety gloves�
•
ensure adequate ventilation�
•
ensure the battery poles are clean� If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.
•
If the battery does not have caps, refer to the
manufacturer instructions on charging and the
charging speed�

Connecting the device

always verify the charging device is disconnected
from the 230 V ac outlet when connecting to a
battery�
1� connect the red (+) terminal connection cable
with clamp (6) to the positive battery terminal�
2� connect the black (-) terminal connection cable
with clamp (5) to the negative battery terminal�
note:
The black (-) clamp can also be connected to the
vehicle chassis (Please refer to the auto maker's in-
structions!)� be sure both clamps have good contact
and are securely seated�
Warning!
Risk of fire and electric shock! If possible, connect
the charger to the 230 V power socket without
extension cable� In exceptions, use the shortest
possible undamaged and unrolled 230 V extension
cable�
3� Plug the charger plug into a 230V power socke�
If incorrectly connected to the battery (reverse
polarity) all four leDs will light up and charging
won't start�