AirSep Free Style Instructions D'utilisation page 20

FreeStyle Universal Power Supply
™
Instructions for Use
Use with Airline Power at Passenger Seat
(with 4-pin connection configurations)
1. Make sure your power supply is securely connected to the FreeStyle
inlet, as shown in Figure 2.
2. Connect the correct DC power cord end to the ACCESSORY DC IN
inlet on the power supply, as shown in Figure 7.
3. Remove the tip of the DC connector by pressing on the tab to expose
the 4-pin connector, as shown in Figure 8.
4. Insert the 4-pin connection to the airline passenger DC socket optionally
available at your seat.
5. To operate the POC, press the FreeStyle [1], [2], or [3] setting on the
unit's top panel, as determined by your prescription. To turn the unit
off, press the setting associated with the LED illuminated above it.
For more information on the universal power supply for
FreeStyle or any AirSep product accessories, please
contact your local equipment provider.
4-GB
AirSep's FAA-approved FreeStyle enables you to use this POC
in-flight on most commercial airlines around the world. Each
airline establishes its own policy for FAA-approved POC use, as
well as the requirements for, and the availability of, optionally
allowing you to power your unit onboard the aircraft. Aircraft-
equipped passenger power may include one or more of the
following sources: an AC power socket, a DC power socket
similar to that typically found in an automobile, or a DC power
socket with a 4-pin configuration.
If the specific airline on which you are travelling allows you to
connect your POC unit at a seat equipped with a 4-pin DC
power configuration, take the following steps:
Figure 7
AirSep
www.airsep.com
Figure 8
Corporation
®
MN169-1 Rev. - 06/10