Movement Keys - Videotec DCBD-DCTEL Manuel D'instructions

7.2.1 Movement keys

The PAN and TILT keys (up/down/left/right): these are used to move the pan & tilt in the 4 directions: Up, Down
(TILT) and Left, Right (PAN). It is also possible to make combined movements by pressing two keys at a time:
up/right, up/left, down/left and down/right.
The AUTOPAN key: this sets the pan & tilt motor in continuous movement between the limit switches in the Left-
Right direction and vice versa (AUTOPAN)
ZOOM TELE and WIDE keys: they activate the corresponding Zoom functions
FOCUS NEAR and FAR keys: they activate the corresponding Focus functions
IRIS OPEN and CLOSE keys: they activate the corresponding Iris functions
AUX key: used with the numeric keys, it activates receiver auxiliaries 1-2-3-4.
Example:
• Keeping AUX pressed down, press the 1/9 key: aux 1 for the selected receiver will be activated
• Keeping AUX pressed down, press the 3/11 key: aux 3 for the selected receiver will be activated
PRESET key (Can only be used with receivers that integrate the corresponding function, e.g. the DTRX3): when
used with the numeric keys (1/9 8/16) it will store up to 8 different positions for PAN & TILT and camera lens
status, which can be recalled later by a SCAN (See SCAN).
Example:
• Keeping PRESET pressed down, press the 1/9 key: this will store, in position 1, the current status of the pan
& tilt and lens positions of the camera controlled by the selected receiver.
• Keeping PRESET pressed down, press the 7/15 key: this will store, in position 7, the current status of the pan
& tilt and lens positions of the camera controlled by the selected receiver.
SCAN key(Can only be used with receivers that integrate the corresponding function, e.g. DTRX3): when used
with the numeric keys (1/9 ... 8/16) it will recall up to 8 different positions for PAN & TILT and camera lens status
that were previously stored using the PRESET function (See PRESET).
Example:
• Keeping SCAN pressed down, press the 1/9 key: the pan & tilt motor controlled by the selected receiver will
move to the previously stored position No. 1.
• Keeping SCAN pressed down, press the 2/10 key: the pan & tilt motor controlled by the selected receiver will
move to the previously stored position No. 2.
To prevent changing the status of the active input/receiver while using one of the function keys AUX,
PRESET or SCAN, first press the(AUX, PRESET or SCAN) function key (and keep it pressed) and then press
the numeric key.
Page 16 MNVCDCBD01_1729_EN