Keys; Key 1: Inverting The Keyboard; Key 3: Joystick Calibration; Keys 4 And 7: Vcom Mode - Videotec DCZ Manuel D'instructions

8.4 Keys

8.4.1 Key 1: Inverting the keyboard

The keyboard can be used:
• By right-handed users (joystick on the right, jog
shuttle on the left);
• By left-handed users (joystick on the left, jog
shuttle on the right).
To invert the keyboard compared to the current
settings:
• Enter setup and press
the setting and return to its normal operating
mode
• Remove the caption panel paying attention to the
fastening tabs, rotate it by 180° and replace it.
• Adjust the feet on the bottom of the keyboard to
obtain the inclination required for each different
surface.
• Carefully remove the USB cable from the bottom
of the keyboard and insert it in the serpentine
making sure it is not a nuisance to the operator.
The inversion of the keyboard has nothing to do with
the PC application which must not be changed.
The orientation of the keyboard can be set using
VCOM commands [Orientation+] and
[Orientation-].

8.4.2 Key 3: Joystick calibration

The joystick can be calibrated if it malfunctions.
To calibrate the joystick:
Enter setup and press
the keyboard will flicker during the calibration phase.
Move the joystick for a few seconds as far as it will go,
in both a horizontal and vertical direction. Rotate the
knob clockwise and counter clockwise several times,
as far as it will go.
Release the joystick to assess its position when idle.
After 5 seconds of inactivity, the keyboard will save
the values and confirm the calibration.

8.4.3 Keys 4 and 7: VCOM mode

Selecting VCOM mode:
Key 4 : Select VCOM mode with reset of the lookup
chart.
7 : (for experts only) select VCOM mode without
Key
reset of the lookup chart.
1
. The keyboard will save
3 . The LEDs in the centre of
4
When key is pressed, all the changes made to
the key lookup chart are cancelled and the default
configuration is reinstated (each key is assigned a
number which corresponds to its default logical
address).
(for experts only) Select key
made to the lookup chart. Some keys may not
necessarily be recognized as they were previously
assigned to the emulation of the joystick keys.
When setup has been completed, disconnect and
then reconnect the keyboard to enforce the changes.

8.4.4 Keys 5 and 8: JOYHID Mode

Selecting JOYHID mode:
Key 5 : select JOYHID mode with reset of the lookup
chart.
Key 8 : (for experts only) select JOYHID mode
without reset of the lookup chart
When key 5 is pressed, all the changes made to
the key lookup chart are cancelled and the default
configuration is reinstated.
(for experts only) Select key
made to the lookup chart.
When setup has been completed, disconnect and
then reconnect the keyboard to enforce the changes.
8.4.5 Key 6: Checking that the keys/
LEDs work
When in VCOM mode, this function lights up a LED
when the relative key is pressed which indicates that
both are working properly.
To reinstate the standard mode, disconnect and
reconnect the keyboard.

8.4.6 Key 9: Configuration reset

The keyboard configuration is reset to default values
(VCOM mode). All changes made to the configuration
(e.g. the key lookup chart) will be lost.
7 to save any changes
8
to save any changes
11