Keyboard And Switching Functions; Video Switching Keys - Videotec DCBD-DCTEL Manuel D'instructions

7 Keyboard and switching functions

DCTEL

7.1 Video switching keys

Mon key (Monitor) : used to change the active output video (monitor) of the controlled matrix. Press the monitor
key repeatedly until the desired monitor is reached. The controlled monitor is indicated by the status of the
Monitor LED's:
• LED Mon1 On: Monitor 1 control (output video 1)
• LED Mon2 On: Monitor 2 control (output video 2)
• LED Mon3 On: Monitor 3 control (output video 3)
• LED Mon4 On: Monitor 4 control (output video 4)
SHIFT key: this key is situated between LED's 1-8 / 9-16. When used alone, its function is to select the camera
group: group 1-8 or group 9-16. The status of the active camera group is indicated by the LED's to the left and
right of the SHIFT key (LED 1-8 and LED 9-16).
Using the SHIFT key and ENTER key together will enter OSM programming for those matrixes that allow it (see
the section on OSM programming for the matrixes).
Numeric keys 1/9 2/10 3/11 4/12 5/13 6/14 7/15 8/16: used for direct selection of the input on the manual
channel of the matrixes (according to the setting for camera group status). The status of the numeric keys is
indicated by lighting up of the corresponding LED's.
Video
switching keys
Telemetry switching
keys
Page 14
DCBD
MNVCDCBD01_1729_EN