Programming The Keyboard Address; Programming The Video Line; Programming The Telemetry Line (Dctel Keyboard Only) - Videotec DCBD-DCTEL Manuel D'instructions

To program the keyboard take the following steps:
1)Position DIP4 to the ON position.
NB: LED 1-8 will start blinking, this shows that the keyboard is in programming mode. LED 1-8 or 9-16 will blink
for the complete duration of the programming phase.
2)Program DCTEL / DCBD or, if required, check keyboard configuration status.
3)When programming has been completed, turn DIP4 to the OFF position. The keyboard will return to the settled
operating mode.

6.2.1 Programming the keyboard address

During the programming phase (LED 1-8 or 9-16 blinking), the keyboard address is visible at all times by viewing
the status of the monitor LED's:
• LED Mon1 on: Address 1
• LED Mon2 on: Address 2
• LED Mon3 on: Address 3
• LED Mon4 on: Address 4
To change the keyboard address press the Monitor key until the desired address is reached.
If more than one keyboard is connected to the same matrix, make sure that each keyboard has a
different address setting. If not, conflicts could arise and/or errors could occur when carrying out video
switching and telemetry commands along the coaxial cable.

6.2.2 Programming the Video line

Video line programming is shown by LED 1-8 blinking. Press the SHIFT key if the blinking LED is 9-16.
Press keys from 1/9 to 8/16 to program matrix line status, according to the table below:
LED 1-8 Blinking.
Key
Type of Protocol
LED On
Key
Baud Rate
LED On
(*)Default setting.

6.2.3 Programming the Telemetry line (DCTEL keyboard only)

Telemetry line programming is shown by LED 9-16 blinking. Press the SHIFT key if the blinking LED is 1-8.
Press the numeric keys from 1/9 to 8/16 to program telemetry line status, according to the two tables below:
LED 9-16 blinking.
Key
Type of Protocol
LED On
Key
Baud Rate
LED On
(*) Default setting.
(**) Only 2400 Baud, fixed speed.
For the DCBD keyboard, there is no telemetry line so any settings made for the telemetry line cannot be
activated from the keyboard. So always make sure to be in the Video line programming phase with LED 1-8
blinking.
1/9
MACRO (*)
LED Cam 1/9 LED Cam 2/10
5/13
1200
LED Cam 5/13 LED Cam 6/14
1/9
MACRO VIDEOTEC (*)
LED Cam 1/9 LED Cam 2/10
5/13
1200
LED Cam 5/13 LED Cam 6/14
2/10
SW164OSM
LED Cam 3/11
6/14
9600
LED Cam 7/15
2/10
PELCO D (**)
Led Cam 3/11
6/14
9600 (*)
LED Cam 7/15
Page 7
3/11
LINXS Videotec Switchers
LED Cam 4/12
7/15
19200 38400 (*)
LED Cam 8/16
3/11
ENEO
Led Cam 4/12
7/15
19200 38400
LED Cam 8/16
MNVCDCBD01_1729_EN
4/12
8/16
4/12
8/16