Gree GWH09ACC-K6DNA1A/I Manuel D'utilisateur page 20

Function introduction for combination buttons
● Under energy-saving function, set temperature can't be adjusted. Press "TURBO"
button and the remote controller won't send signal.
● Sleep function and energy-saving function can't operate at the same time. If
energy-saving function has been set under cooling mode, press sleep button will
cancel energy-saving function. If sleep function has been set under cooling
mode, start up the energy-saving function will cancel sleep function.
8℃ heating function
Under heating mode, press "TEMP" and "CLOCK" buttons simultaneously to start
up or turn off 8℃ heating function. When this function is started up, "
will be shown on remote controller, and the air conditioner keep the heating status
at 8℃ . Press "TEMP" and "CLOCK" buttons simultaneously again to exit 8℃
heating function.
Note:
● Under 8℃ heating function, fan speed is defaulted at auto speed and it can't be
adjusted.
● Under 8℃ heating function, set temperature can't be adjusted. Press "TURBO"
button and the remote controller won't send signal.
● Sleep function and 8℃ heating function can't operate at the same time. If 8℃
heating function has been set under cooling mode, press sleep button will cancel
8℃ heating function. If sleep function has been set under cooling mode, start up
the 8℃ heating function will cancel sleep function.
● Under ℉ temperature display, the remote controller will display 46 ℉ heating.
Child lock function
Press "▲" and "
child lock function is on, "
the remote controller, the "
the unit.
Temperature display switchover function
Under OFF status, press "
erature display between ℃ and ℉ .
" simultaneously to turn on or turn off child lock function. When
" icon is displayed on remote controller. If you operate
" icon will blink three times without sending signal to
" and "MODE" buttons simultaneously to switch temp-
16
" and "8℃ "