Gree GWH09ACC-K6DNA1A/I Manuel D'utilisateur page 18

Introduction for buttons on remote controller
"▲" or " " button within 5s to set clock time. Each pressing of "▲" or "
clock time will increase or decrease 1 minute. If hold "▲" or "
time will change quickly. Release this button when reaching your required time.
Press "CLOCK" button to confirm the time. "
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s. Otherwise, remote contro-
ller will quit setting status. Operation for TIMER ON/TIMER OFF is the same.
12
QUIET button
Press this button, the Quiet status is under the Auto Quiet mode (display "
"AUTO" signal ) and Quiet mode (display "
signal of " " displayed), after powered on, the Quiet OFF is defaulted.
Note:
● The Quiet function can be set up in all modes; Under the Quiet mode,the fan
speed is not available.
● When quiet function is selected
Under cooling mode: indoor fan operates at notch 4 speed. 10 minutes later or
when indoor ambient temperature≤28℃, indoor fan will operate at notch 2 speed
or quiet mode according to the comparison between indoor ambinet temperature
and set temperature.
Under heating mode: indoor fan operates at notch 3 speed or quiet mode according
to the comparison between indoor ambient temperature and set temperature.
Under dry, fan mode: indoor fan operates at quiet mode.
Under auto mode: the indoor fan operates at the auto quiet mode according to
actual cooling, heating or fan mode.
● The Quiet function is only available for some models.
13
WiFi button
Press " WiFi " button to turn on or turn off WiFi function. When WiFi function is
turned on, the " WiFi " icon will be displayed on remote controller; Under status
of remote controller off, press "MODE" and " WiFi " buttons simultaneously for 1s,
WiFi module will restore to factory default setting.
● This function is only available for some models.
14
LIGHT button
Press this button to turn off display light on indoor unit. "
controller disappears. Press this button again to turn on display light. "
displayed.
15
button
Press this button to achieve the on and off of healthy and scavenging functions in
operation status. Press this button for the first time to start scavenging function;
" icon stops blinking.
" singal) and Quiet OFF (there is no
14
" button,
" button, 2s later,
" and
" icon on remote
" icon is