Safety Rules - Avdel 74110 Manuel D'instructions

S a f e t y R u l e s
This instruction manual must be read with particular attention to the following safety rules, by any
person installing, operating, or servicing this tool.
1 Do not use outside the design intent.
2 Do not use equipment with this tool other than that recommended and supplied by Avdel UK Limited.
3 Any modification undertaken by the customer to the tool/machine, nose assemblies, accessories or any equipment
supplied by Avdel UK Limited or their representatives, shall be the customer's entire responsibility. Avdel UK Limited
will be pleased to advise upon any proposed modification.
4 The tool/machine must be maintained in a safe working condition at all times and examined at regular intervals for
damage and function by trained competent personnel. Any dismantling procedure shall be undertaken only by
personnel trained in Avdel UK Limited procedures. Do not dismantle this tool/machine without prior reference to the
maintenance instructions. Please contact Avdel UK Limited with your training requirements.
5 The tool/machine shall at all times be operated in accordance with relevant Health and Safety legislation. In the U.K.
the "Health and Safety at Work etc. act 1974" applies. Any question regarding the correct operation of the
tool/machine and operator safety should be directed to Avdel UK Limited.
6 The precautions to be observed when using this tool/machine must be explained by the customer to all operators.
7 Always disconnect the airline from the tool/machine inlet before attempting to adjust, fit or remove a nose
assembly.
8 Do not operate a tool/machine that is directed towards any person(s).
9 Ensure that vent holes do not become blocked or covered and that hoses are always in good condition.
10 The operating pressure shall not exceed 6.3 bar - 94 lbf/in
11 Do not operate the tool without full nose equipment in place.
12 When using the tool, the wearing of safety glasses is required both by the operator and others in the vicinity to
protect against fastener projection, should a fastener be placed 'in air'. We recommend wearing gloves if there are
sharp edges or corners on the application.
13 Take care to avoid entanglement of loose clothes, ties, long hair, cleaning rags etc. in the moving parts of the tool
which should be kept dry and clean for best possible grip.
14 When carrying the tool from place to place keep hands away from the trigger/lever to avoid inadvertent start up.
15 Always adopt a firm footing or a stable position before operating the tool and be aware of a torque reaction on the
hands when the tool is operating, particularly during the reversing sequence. Grip the tool firmly to be able to
counter the torque reaction, but not too tightly.
16 Keep hands away from the rotating drive screw and the nose end of the tool. If a fastener becomes jammed on the
drive screw, shut off the air supply and drain the supply line to the tool before attempting to dislodge it.
17 The tool is not electrically insulated.
18 This tool is not designed for use in combustible or explosive atmospheres.
4
2 .