Maintenance; Lubrication; Care Of Your Dryer; Dryer Interior - ALLIANCE D677I Installation/Fonctionnement/Entretien

Lubrication

All moving parts are sealed in a permanent supply of
lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.

Care of Your Dryer

WARNING
To reduce the risk of an electric shock,
serious injury or death, disconnect the
electrical service to the dryer before
cleaning the interior.

Dryer Interior

Wipe the surfaces using a soft cloth and household
cleaner or a non-abrasive paste of powdered laundry
detergent and hot water, followed by a short heat cycle
with a load of rags.
To remove crayon or ball point ink off the dryer drum,
put the heat on high and use old rags in the dryer to
absorb the crayon or ink. If unsuccessful, contact the
appliance dealer. DO NOT use any chemicals in the
dryer.
IMPORTANT: The use of chlorine bleach for
removing any discolorations should be avoided
because bleach could damage the finish.

Cabinet

Wipe the dryer cabinet as needed. If detergent, bleach
or other washing products have been spilled on the
dryer, wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.

Control Panel

Use only a damp or sudsy cloth for cleaning the
control panel. Some spray pretreat products may harm
the finish on the control panel.
NOTE: The wiring diagram is located inside the
control panel.
WARNING
Label all wires prior to disconnection
when servicing controls. Wiring errors
can cause improper and dangerous
operation.
512681

Maintenance

W132
W049
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Exhaust System

WARNING
To reduce the risk of electric shock,
disconnect the electrical service to the
dryer before cleaning.
The exhaust duct should be inspected after one year of
use and cleaned if necessary by a qualified service
person to remove any lint build-up. Inspect and clean
exhaust duct every one to two years as required
thereafter.
The weather hood should be checked frequently to
make sure the dampers move freely, dampers are not
pushed in and that nothing has been set against them.
Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors and
liquids.
Do not obstruct the flow of combustion and ventilation
air.
NOTE: Verify proper operation after servicing.

Lint Filter

CLEAN THE LINT FILTER BEFORE DRYING
EACH LOAD. (Refer to Figure 55 for lint filter
location.) Cleaning the lint filter is important because
a layer or pad of lint on the filter will block the flow of
air through the dryer, thus reducing the efficiency of
the dryer. The clothes will take longer to dry and
energy will be wasted.
The lint filter may be washed if needed. Annually
remove lint filter and screw to vacuum the duct under it.
1 Lint Filter
Figure 55
W043
1
D608I
D608I
41