Step 7: Recheck Steps 1-6; Step 8: Check Heat Source - ALLIANCE D677I Installation/Fonctionnement/Entretien

Installation
DO NOT
OVERLOAD
CIRCUITS
Figure 27
WARNING
To reduce the risk of an electric shock or
fire, DO NOT use an extension cord or an
adapter to connect the dryer to the
electrical power source.
Grounding Instructions
The dryer must be grounded. In the event of
malfunction or breakdown, grounding will reduce the
risk of electric shock by providing a path of least
resistance for electric current. The dryer is equipped
with a cord having an equipment-grounding conductor
and a three-prong grounding plug. The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
24
D009I
W037
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Improper connection of the equipment-
grounding conductor can result in a risk of
electric shock. Check with a qualified
electrician or service person if you are in
doubt as to whether the dryer is properly
grounded.
DO NOT modify the plug provided with the dryer – if
it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
If the laundry room's electrical supply does not meet
the above specifications and/or if you are not sure the
laundry room has an effective ground, have a qualified
electrician or your local electrical utility company
check it and correct any problems.

Step 7: Recheck Steps 1-6

Refer to Installer Checklist on the back cover of this
manual and make sure that dryer is installed correctly.

Step 8: Check Heat Source

Electric Dryers
Close the loading door and start the dryer in a heat
setting (refer to the Operation section). After the dryer
has operated for three minutes, the exhaust air or
exhaust pipe should be warm.
W038
512681