Slide Extension - ALLIANCE D677I Installation/Fonctionnement/Entretien

Slide Extension

(Coin Slide Models Only)
1. Remove slide extension parts from parts
accessories bag included in unit.
2. If installing a Greenwald coin slide, position
extension lever (to be installed on extension
bracket) with arm that has one star facing down.
Refer to Figure 30.
Greenwald
Coin Slide
One Star
Figure 30
3. If installing a Monarch or ESD coin slide,
position lever with arm that has two stars facing
down. Refer to Figure 30.
4. Install extension lever with rounded corner facing
away from extension bracket using bolt, one or
two flat washers (shims) (use number of washers
included in kit) and nut. Refer to Figure 31. Make
sure washers are flat against bracket.
Bolt
Spring
Loops
Extension Bracket
Star(s) Facing Down
Figure 31
5. Torque nut between 2 and 2.26 Nm (18 and 20
inch-pounds), or tighten nut firmly.
512681
Monarch or
ESD Coin Slide
Two Stars
TLW2088N
One or Two
Flat Washers (Shims)
Rounded Corner
Nut
Extension Lever
TLW2089N
TLW2089N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
6. Install extension spring in bracket hole and hole in
upper arm of lever. Refer to Figure 31.
7. Bend loops closed after installation.
8. Check to make sure the lever swings freely.
Installing Extension Onto Coin Slide:
Option 1
1. Install slide extension onto top of coin slide using
two remaining screws and lockwashers. Refer to
Figure 32.
Lockwashers
Coin Slide
Figure 32
2. Insert coins and partially extend coin slide.
3. Insert coin slide on its side through meter case
opening. Then rotate 90 degrees to its proper
orientation.
4. Return coin slide and hook slide pins onto meter
case.
5. Continue coin slide installation according to
manufacturer's instructions.
NOTE: During coin slide installation, make sure
activation lever is up and off the switch. Refer to
Figure 33.
Vending
Attaching
Screws
Slide
Extension
TLW1564K
31