Installation And Connection - Dometic WAECO AMP100 Instructions De Montage Et De Service

AMP100
6

Installation and connection

6.1 Tools required
For installation and assembly you require the following tools:
Measuring ruler (fig. 3 4, page 4)
Centre punch (fig. 3 5, page 4)
Hammer (fig. 3 6, page 4)
Drill bit set (fig. 3 7, page 4)
Drill (fig. 3 8, page 4)
Screwdriver (fig. 3 9, page 4)
For making and testing the electrical connection the following tools are required:
Diode test lamp (fig. 3 1, page 4) or voltmeter (fig. 3 2, page 4)
Insulating tape
Heat shrinking sleeve
Hot air blower (fig. 3 10, page 4)
Crimping tool (fig. 3 11, page 4)
Soldering iron, if required (fig. 3 12, page 4)
Solder, if required (fig. 3 13, page 4)
Cable bushing sleeves, if required
6.2 Installing and connecting the control box
The control box is supplied ready for installation.
➤
Install the control box in a location protected from water near the monitor, prefera-
bly under the dashboard.
Make sure to consider the length of the cable.
➤
Attach the control box using the supplied screws.
➤
Insert the plug and the cable set in the connection provided (12 - 24 V) on the switch
box.
➤
Connect the brown cable (fig. 5 9, page 6) to earth.
➤
Connect the red cable (fig. 5 8, page 6) to an active positive line (such as
terminal 15).
Warning!
Ensure that you connect the control cables correctly to + PLUS an not to
earth. Connecting the control cables to earth can damage the device.
➤
Connect the green cable (fig. 5 5, page 6) to the positive cable of the reversing
light.
Installation and connection
21