Dometic WAECO AMP100 Instructions De Montage Et De Service page 22

Installation and connection
On some vehicles, the reversing light only works when the ignition is switched
on. In this case, you must switch on the ignition in order to identify the positive
and earth wires.
➤
Connect the black cable with the round plug lug (fig. 5 7, page 6) to the monitor
connection labeled S/BY or to the violet-white cable of NAV-7300 navigation system
monitor.
The monitor receives its activation signal via this cable.
➤
Connect the plug (fig. 5 3, page 6) to the monitor.
➤
Connect the plug (fig. 5 4, page 6) to the camera.
Warning!
Ensure that all lines are connected correctly. The control line may never be con-
nected to earth; doing so can damage the device. Make especially sure to in-
sulate the bare end of the control line when it is not in use and thus not
connected.
If a video source in addition to the rear view camera – such as a navigation system or DVD
player – is connected to the monitor and you would like to activate the camera when
parked or moving fowards, you need to connect the black control cable with the flat plug
lug to the RV-AMP-SW rocker switch (available as an accessory).
Proceed as follows:
➤
Select a suitable installation location for the switch, such as on the dashboard near
the monitor.
Caution!
Before making any drill holes, ensure that no electrical cables or other parts of
the vehicle can be damaged by drilling, sawing and filing.
➤
Drill a hole approximately 20 mm in diameter.
➤
Mount the switch.
➤
Plug the black cable with flat plug lug (fig. 5 6, page 6) into a connection on the
switch.
Warning!
Ensure that you connect the control cables correctly to + PLUS an not to
earth. Connecting the control cables to earth can damage the device.
➤
Connect the other switch connection to a positive line with 12 V to 24 V.
22
AMP100